The gap is too big. Is it good to make a beautiful seam

Many owners are stuck in ceramic tile after just plan to do the beautiful sewing agent, because did not discuss with the master beforehand, some gap was made even caulking agent, reserved ceramic tile gap shallow and small.Such a gap to do after the tile grout, or more trouble, so want to do the true porcelain glue owners can be reserved in advance. Some owner did so really, worry aperture is not enough however, the width of reservation is a bit big. Then the gap is large can make grout for tiles?What kind of effect will it have?

First, why should ceramic tile reserve gap?
Ceramic tile is burned through high temperature and become, encounter cold encounter heat can have all sorts of reaction, heat bilges cold shrink is the phenomenon that all ceramic tile exists. Certain aperture should be reserved when sticking brick, basically be to let ceramic tile can have free the space that collects put, still convenient master sticks brick, also can assure certain beautiful. And leave a gap, ceramic tile does not appear arched phenomenon, more convenient follow-up to do the gap filling adhesive.
Two, ceramic tile gap how much more appropriate?
The size of aperture is not certain, the beautiful degree that can be fond of according to oneself, ceramic tile will decide, also can communicate with stick brick master beforehand, they can decide appropriate aperture according to the type of ceramic tile. Generally speaking, the width that domestic ground ceramic tile leaves seam is between 1.5mm-2mm, this also fits to do beautiful seam quite. But if you want a more obvious effect, you can also reserve a little width, the maximum width should not exceed 4mm.
Three, ceramic tile gap is too wide, how should do the tile adheisve?
Common problem is gap is too small to want how to do beautiful seam, below this kind of circumstance can empty gap only, enlarge the space inside gap as far as possible, do not hurt ceramic tile when clearing. But if the gap is too wide, in order to ensure the sealant adhesion, the bottom of the gap must be cleaned. If the gap is too deep, you can fill the seam first, and then clean out the depth of about 3mm, which can not only save cost, but also provide a clean and flat bottom of the gap.

It is of course a good thing to leave the seam, but Kelin tile grout manufacturer does not recommend that we specially reserve too wide gap, because the gap of some ceramic tiles will be more beautiful, but not less than 1mm.Moreover, the gap is too wide, and the amount of sealant is large, and the cost of decoration is also much higher.