Teach you how to accept sealant

Home decoration is to make beautiful seam not only to ensure gap beautiful, also be to can let gap waterproof moistureproof, protect the use of ceramic tile.Good effect of beautiful seam depends not only on high-quality beautiful seam products, but also on skilled construction techniques.

Many owners may not know how to conduct acceptance after finishing the sewing. Today, Kelin two-component adhesive supplier share a few acceptance tips with you, hoping to help you.

First look at the beauty of the seam

After making perfect sewing, we should first observe the effect of ceramic tile seam, mainly observe whether the color of beauty sewing agent is fading, discoloration and abnormal phenomenon. We can intuitively judge with the naked eye, and the general beauty still needs to feel by ourselves.

If you feel that the color of sealant is not normal, you can ask the sealant to take out the sealant color plate on site for comparison and verification. Avoid the phenomenon of serious color difference.

Observe the flatness and depression of sealant and ceramic tile

This requires careful inspection to find, the owner at the time of inspection, need to see and touch the seam an agent and ceramic tile, in every corner of the flatness, and degree of depression, generally conform to standard the beauty of the sewing process, whether level off, after touch, can feel it, if in the process of touch, could not touch the seam an agent, that beautiful seam an agent sag is too deep, is not in conformity with the standards,Even if it does not look beautiful, it will accumulate dust for a long time, and it will affect the beauty.

Check that the material is firm

Can try a hand on the surface of seam an agent, the test material is fully cured, after curing is hard, if after curing the soft condition, is likely to be the problem of seam an agent material, the beauty of this curing effect of seam an agent is completely show not to come out, life is too short, no antifouling performance, made is white.

Whether there are bubbles in the sealant and whether it is firm

Bulge is generally caused by the dirt in the gap during the construction. It is generally caused by the fact that the gap is not completely filled when the sealant is played by the sealant division. During the acceptance, we need to observe whether there are bubbles in the gap and press the sealant by hand to test whether the sealant is firm.

Check the residue cleaning after curing

Carefully observe whether the edge of the seam is neat and whether the residual material after curing of the sealant is cleaned up, especially the residual sealant cleaning problem. When accepting the sealant, it is best to ask the master to clean up, otherwise it is difficult for the owner who is not familiar with the material properties to clean up by himself.