Home > News > INDUSTRY NEWS > Construction method of Yin and Yang Angle
Certifications
Follow us

Construction method of Yin and Yang Angle

Construction method of Yin and Yang Angle

2021-11-20 14:49:02

We have already introduced the construction method of tile grout construction, but there is no detailed introduction on how to construct the place of Yin and Yang Angle.Today detailed explanation, I hope to help you.

1. Shade Angle construction

Shade horn is to point to the corner that the concave goes on metope, also call inside horn, be like the 4 angles of the room, also for instance metope and the place that the ground intersects.

Glue: it is necessary to pay attention to whether there is a gap in the negative corner of the ceramic tile. If not, the sewing master needs to polish or glue after opening the seam, otherwise the sealant is easy to fall off.

Pressure seam: in the pressure seam, you need to use professional Angle pressure seam tools, generally speaking, Angle pressure seam tools are relatively small. The tungsten steel pressing machine of Kelin beauty seam agent can be dual-use, one side is suitable for the ground or wall pressing, and the other side is smaller for the Yin Angle pressing.

 


 

2. Yang Angle construction

Yang Angle refers to the corner projecting from the wall.

Glue: the same as the normal wall and ground construction, need to align the gap and then evenly glue.

Pressure seam: there are many kinds of positive Angle pressure seam, using different professional positive Angle pressure seam tools can complete the rounded Angle, flat Angle and right Angle effect.These ways have their own characteristics, if the owner does not have special requirements, the construction team of Kelin filling grout will choose to do the rounded Yang Angle pressure joint.

 


 

3. Cross corner construction

Glue: do not pay too much attention to the speed. Once the speed slows down, it is easy to cause the accumulation of sealant. If so, each cross Angle will cause waste due to the multi-use of sealant.

Pressure seam: pressure seam piece and ceramic tile into an Angle of about 30 degrees, uniform pressure over a cross Angle gap, and then with the intersection as the starting point of pressure seam on both sides.

According to the experience of the construction workers of Kelin epoxy gap filler supplier, it is recommended to do the pressing joint of the Yin and Yang Angle first and then do the pressing joint of other walls and floors, so as to achieve the best effect, without the second rework.Above is the construction experience that the worker shares with us, hope can help everybody.