Also can do at home

Spring, the beginning of a year. Due to COVID-19, making the decoration season be greatly affected. But no need to be afraid, we can try to start work ourselves, bringing a small change to our home. First of all, start from that small gap! The following Kelin ceramic tile grout manufacturer to explain the construction steps of tile grout.

1. Clean up the gap

Clean the gaps also need clean the edge cement in the tile. Reoccupy "vacuum cleaner" (high power <1500 watts above >) gap of metope and ground ceramic tile by go up to next, from inside to outside careful adsorption, clean up thoroughly the sundry inside gap of ceramic tile.

2. Wipe

After cleaning the gaps in the ceramic tiles, wipe them repeatedly with a semi-wet towel to ensure that there is no black edge on the side wall of the ceramic tile joint again and improve the beauty of the tile grout.

3. Gluing

Gluing, select tile grouting area and colloid color, glue gun loaded with tile grout products, slowly push glue. At the same time, according to the size of the tile joint, but also cut the appropriate diameter of the glue pipe, the mouth of the cutting is slightly larger than the gap. The mixing nozzle will be cut into a 45° Angle, and the gel will be evenly hit all the gaps in the ceramic tile with the glue gun. The glue process should not stop as far as possible.

4. Gap Pressing

According to the width of the ceramic tile gap, choose the appropriate tools (scraping blade, tungsten steel round rod, steel ball, etc.), start from the Angle of the external pressure gap, gently scrape the gap of the cross interface, the interface translation and pressure well, the requirements are smooth, there is no obvious node, with the center of the cross interface at the origin of the reverse desire for external pressure glue, the requirements are smooth.

5. Remove extra grout

After the construction of the grouting, the shovel can be used to remove the excess materials in 4-5 hours. After the ground is fully cured in 48 hours, it can be used normally. In order to increase the service life of the tile grout, it is recommended not to use a large amount of clear water within a week. In this way, the composition of the tile grout can give full play to the effect and solidify more completely.

6. Check and accept

Finally, carefully check the tile grout gaps, if there is no problem can be a perfect finish!